Wooden stair treads are an important part of any home’s staircase, and when they need to be replaced, the job is often a lot more complicated than you might think. That’s because installing new treads requires that you do some careful measuring and cutting before anything else can happen.
What are Wood Stair Treads?
Wood stair treads are covers that are made of wood that are cut to measure and install over the steps on stairs that are made of concrete. Stair treads Houston are sold in packages that typically contain 20 to 10 ft long sections of wood. However these can be purchased at any length.
Can You Install Wood Stair Treads To Concrete?
Yes, treads can be installed on concrete when it has been treated with a product that is specially designed for this task. The other option is to use special glue specifically for attaching the two surfaces together. If it has only been a week since the concrete was poured and it is clean, then you should not have a problem. If you’re not sure what to do, ask a contractor if they can help you before you begin or if they could actually install the treads for you.
What Are The Tools Required To Attach Wood Stair Treads To Concrete?
Once you have made your purchase, a few tools that are required for installation are: A saw, pen, measuring tape, stud finder, screw gun and screws. You will also need latex primer and water-based polyurethane sealant.
Steps for Attaching Wood Stair Treads To Concrete in Houston
1) Measure up from the ground both inside and outside corners of the staircase.
2) Thoroughly clean the surface on either side of the stairs where you will be installing your new stair treads in Houston which should also be cut at a 45 degree angle according to your measurements.
3) Apply latex primer over all four sides of each piece and let dry. Then apply a second coat and let dry for 24 hours before finally sealing with two coats of water-based polyurethane.
4) Nail down one end of the stair with a Pneumatic Nailer.
5) Attach your stud finder to a long board and drive screws through it into each tread in order for the screw heads to act as nails when you are attaching them to concrete.
6) Slide your stairs and attach them from underneath with 3″ galvanized deck screws so that they will not jiggle or rattle once installed.
7) Take out the remaining nails and remove all loose pieces such as dust, sawdust, etc.
8) Once completely dry, you can sand around any exposed wood paint then stain or paint accordingly if needed.
How Long Should It Take To Attach Wood Stair Treads To Concrete?
It will usually take 4 to 6 hours to install and conceal the concrete in your staircase. The time varies depending on how many steps you have, but keep in mind that they need to be installed properly so that the tread does not pose a tripping hazard.
Conclusion Hopefully, this article has given you the information that you need to know about how to attach wood stair treads to concrete. You should be able to get your stairs looking great in no time with these easy steps.